16 operating manual, Preface, Rx600 s6 – FUJITSU PRIMERGY RX600 S6 User Manual
Page 16
16
Operating Manual
RX600
S6
Preface
©
c
og
ni
ta
s.
Ges
el
ls
ch
ft f
ü
r T
e
ch
ni
k-
D
ok
um
e
nt
a
tio
n m
bH
201
1
P
fad:
C:
\P
rog
ra
m
m
e\
F
C
T
\ti
m
_a
pp
\ti
m
_l
o
ca
l\w
or
k\
P
ICH
OL
\O
B
J_
D
OK
U
-1
1
93
5-
00
1.
fm
The accessible drives/components integrated in these locations cannot be
replaced during operation.
Power supply
The server has up to four hot-plug power supply units that automatically switch
to a mains voltage of 100 - 127 V / 200 - 240 V. This ensures redundant power
supply. If one power supply unit is defective, the other(s) then guarantee(s)
unimpaired operation. The faulty power supply unit can be replaced during
operation (for further details see
"Hot-plug power supply units" on page 87
Cooling
Each processor has a heat sink. Further cooling for the installed processors is
provided by hot-plug fans (optionally in a redundant configuration).
Temperature sensors variably adjust the fans. If a temperature sensor fails or is
removed, the fans affected run at maximum speed so as to provide the greatest
possible protection for the hardware.
If a fan fails, unimpaired further operation is ensured. A defective fan module
can be replaced during operation (for further details see
).
High level of availability and data security
When memory data is accessed, 1-bit errors in the main memory are identified
and automatically corrected with the ECC (Error Correcting Code) method. The
patented memory scrubbing function regularly starts up the EDC mechanism
(Error Detection Code) and thus ensures continuous data integrity.
The memory modules used support SDDC technology (Chipkill™), which
further increases the effectiveness of memory error monitoring and correction.
Support is likewise provided for hot-spare memory technology, in which a
memory module is used like a replacement module. If a memory module fails,
the module with the defective memory is automatically deactivated and the
replacement module is activated (provided it has been configured for
appropriately in the BIOS). The deactivated memory module is no longer used
and the faulty memory module can be replaced at the next opportunity. In order
to be able to use the hot-spare memory function, all occupied DIMM slots must
have an identical memory configuration.
Memory modules can be protected against failure through mirroring (memory
mirroring, requires two or four memory modules).