Furuno NAVNET 1833 - Manual (Page 48)

2. RADAR OPERATION
2-14
2.10.4 Erasing a VRM, VRM indication
Press appropriate VRM soft key, then press the [CLEAR] key. The VRM is
erased and its indication becomes blank.
2.10.5 Erasing EBL/VRM data boxes
Press the EBL or VRM soft key associated with the EBL/VRM data box you wish
to erase. Press the [CLEAR] key once or twice to erase the data box.
2.10.6 Hiding EBL/VRM data boxes
Press the ZOOM & D. BOX and D. BOX ON/OFF soft keys to show or hide the
EBL/VRM data boxes.
2.10.7 Moving EBL/VRM data boxes
When an EBL/VRM data box is obscuring a target you want to see, you can
move it to another location as shown below. This cannot be done when the
EBL/VRM soft keys are shown.
2. Press the [EBL/VRM] key to erase the EBL/VRM soft keys.
3. Using the trackball, place the cursor inside the data box you wish to move. As
the cursor enters the box it changes to a “hand.” Push the [ENTER] knob,
and the hand changes to a fist, meaning the box is correctly selected.
3. Use the trackball to move the data box to the location desired, then push the
[ENTER] knob.