Furuno NAVNET 1833 - Manual (Page 38)

2. RADAR OPERATION
2-4
2.5 Reducing Sea Clutter
2.5.1 How the A/C SEA works
Echoes from waves can be troublesome, covering the central part of the display
with random signals known as “sea clutter”. The higher the waves and the higher
the antenna above the water, the further the clutter will extend. Sea clutter may
affect radar performance because real targets are sometimes hidden by the
echoes of small waves. (See the left-hand figure in the figure below.) When sea
clutter masks the picture, adjust the A/C SEA to reduce the clutter.
The A/C SEA reduces the amplification of echoes at short ranges (where clutter
is the greatest) and progressively increases amplification as the range increases,
so amplification will be normal at those ranges where there is no sea clutter.
A/C SEA adjusted;
sea clutter suppressed
Sea clutter at
screen center
Effect of A/C SEA
2.5.2 Adjusting the A/C SEA
A/C SEA should be adjusted so that the clutter is broken up into small dots, and
small targets become distinguishable.
1. Press the [GAIN] key.
2. Press the A/C SEA soft key to show the A/C SEA setting window.
A/C SEA
0
A/C SEA setting window
3. Rotate the [ENTER] knob to adjust. The range of adjustment is 0-100. Do not
overadjust – weak targets may be missed.
4. A/C SEA and A/C RAIN can be automatically adjusted. Press the A/C AT
ON/OFF soft key to select ON or OFF as appropriate. When turned on, it
overrides A/C SEA and A/C RAIN settings.
5. Press the [GAIN] key on the front panel or RETURN soft key to finish.