Furuno NAVNET 1833 - Manual (Page 180)

5. CUSTOMIZING YOUR UNIT
5-10
4. Select function desired with the trackball, then press the ENTER soft key or
[ENTER] knob to register your selection.
5. Press the [MENU] key to close the menu.
Plotter function keys
Menu Item Function
Function Key
Label
OFF Assigns no function. —
ADD: ADD NEW WPT Registers waypoint at cursor position. Place
cursor for waypoint location then press function
key. ADD
MWP: MOVE WPT Moves selected waypoint to different position.
Select waypoint, press function key, move
waypoint, then push [ENTER] knob. MWP
RUL: RULER Measures range and bearing between two
points. Set cursor on location, then read range
and bearing at top of screen. To change origin
point, press START POINT soft key. RUL
GWP: GOTO WPT Specify waypoint to set as destination. Enter
waypoint name in window, then press the
ENTER soft key. GWP
GRT: GOTO ROUTE Specify route to follow. Enter route name in
window, then press the ENTER soft key. GRT
EML: EDIT MK/LINE Displays mark & line menu. Press appropriate
soft key to access menu item. EML
TRK: TRACK ON/OFF Each press starts or stops recording/plotting
own ship’s track. TRK
TTM: TTM ON/OFF Turns TTM (Target Track Message) display
on/off. TTM
DTT: DEL TGT TRACK Erases all TTM track. DTT
ALP: ALPHA LIST Displays waypoint alphanumeric list. ALP
LCL: LOCAL LIST Displays waypoint local list. LCL
RTE: ROUTE LIST Displays route list. RTE
DBX: D. BOX ON/OFF Shows/hides data boxes. DBX
CHG: CHANGE CNTRL Changes control in combination screen. CHG
Note: To use CHANGE CNTRL set it on all displays, with the same soft key number.