FUJITSU C145-C037-01EN User Manual

Page 25

3-5

Specification

Paper crease: single-sided; 1/1,000 sheets

double-sided; 1/500 sheets

Conditions and environment

• Printing ratio: 5%
• 23˚C, 50% RH
• Recommended paper

Notes:

1) Paper feeding with the MFF may crease a sheet of paper

depending on loading conditions.

2) Light crease having no practical problem (no affect to legibility)

should not be counted.

Paper curl:

30 mm or less

Conditions and environment

• Printing ratio: 5%
• 23˚C, 50% RH
• Recommended paper

Input voltage

110 to 120 VAC +6%/-10%, 50/60 Hz +2%/-4%

(*14)

220 to 240 VAC +6%/-10%, 50/60 Hz +2%/-4%

Input current

9 A or less (120 VAC)
4.5 A or less (230 VAC)

Power consumption
Maximum

700W (at 120 VAC or 230 VAC, excluding inrush
current)

Average

450 Wh or less (at 120 VAC or 230 VAC)

during printing

Sleep mode

45 Wh or less (at 120 VAC or 230 VAC)

Insulation resistance

10 M

Ω

or more with 500 V megger

(primary-ground)

Dielectric strength, one minute 1,000 VAC (120 VAC)
(primary-ground)

1,500 VAC (230 VAC)

Leakage

0.5 mA or less (at 120 VAC and 60 Hz)

current

3.5 mA or less (at 230 VAC and 60 Hz)

Inrush current

90 A or less (at 120 VAC or 230 VAC and 60 Hz)

(for cold start)

Applied to first turnig on after leaving power

turned off more than 12 minutes.

Momentary

0.5-cycle 100% dip at 120 VAC or 230 VAC (50/

power failure

60 Hz)

AC line noise

1 kV or more, pulse width 100 to 800 ns

Electrostatic strength

9 kV or more

(conforming to IEC 801-2/91)

150

Ω

, 150 pF

(no mismovement, no misprinting)

Surge voltage (lightning)

1.2 kV, pulse width: 40

No.

Item

Paper transport stability (*13)

Notes:

1) This specification applies to the