FUJITSU C145-C037-01EN - Manual (Page 15)

1-5
1.6 Wide Variety of Interfaces and Emulations
The PrintPartner 20W comes standard with two bidirectional Centronics parallel interfaces (IEEE1284 TYPE-B and
TYPE-C connectors) and an RS-232C serial interface (D-SUB 9-pin connector). Three optional interface boards,
LocalTalk (AppleTalk compatible), Ethernet (TCP/IP, IPX/SPX, and EtherTalk corresponding), and IrDA (infrared
adapter), are offered.
The PrintPartner 20W comes standard with the HP LaserJet 5 emulation and the PostScript level 2 compatible
emulation.
An interface board slot and an emulation card connector are provided. Figure 1.3 shows installation of an interface
board and an emulation card. No emulation card is planned presently.
Figure 1.3 Optional interface and emulation
1.7 Environment Friendly
The PrintPartner 20W uses a toner recycle mechanism that does not generate toner waste. This means that the
printer uses toner effectively and the operator does not need to deal with wasted toner.
The power-saving design (intelligent heater on/off sensing) reduces power consumption.
Ozone emission is low.
Plastic parts are marked with the plastic content for ease of product recycling.
The user-selectable economy mode extends the lifetime of the toner bottle.
Optional
interface
board
Emulation card
Bottom connector
Standard
interface
connectors