FUJITSU fi-5950 - Manual (Page 240)

220
8.28 Overscan Control
8.28 Overscan Control
Specify [Optimize] when you use Overscan and the image is partially missing due to an abnormal skew.
You can detect abnormal image skew and set sufficient amount of black margins on the top and the bottom
so that the whole image is contained.
Configure the settings for Overscan Control as follows.
1. Start up the Software Operation Panel.
Refer to “8.1 Scanner Settings” on page 173 .
2. Select [Device Setting 2] from left side list in the window, and select
[Overscan Control] from its lower level.
Added margin
Added margin
When parts of the image are
missing When [Optimize] is specified
missing