FUJITSU fi-5950 - Manual (Page 100)

80
3.6 Skipping blank Pages
4. Check the [Blank Page Skip] box.
When the check box is marked, “Cache Mode” will change to “Use both memory”.
5. Using the slider control under [Blank Page Skip], specify the Blank Page
Skip degree.
For white pages, use the [Black Dots Ratio] slider bar to set the skip condition. For black pages,
use the [White Dots Ratio] scroll bar to set the skip condition.
The value displayed to the right of the scroll bar displays the noise ratio(*1). If a scanned
document is below this value, it is recognized as a blank page. The range is OFF(- -) and from
0.2% to 3.0% (in increments of 0.2%).
*1: Ratio of black dots included in the scanning area. (for white pages)
The [TWAIN Driver] dialog box will be redisplayed. Then, perform the scanning operation on
the dialog box.
Use the slider bar to set the skip condition in five stages from 1 to 5. The bigger the value, the
more likely a page will be detected as blank.