Sol v ing common pr oblems – FUJITSU fi-5950 User Manual

Page 159

139

6.2 Error messages of the Operator panel

SOL

ING COMMON PR

OBLEMS

*2 Turn off the scanner. Reinstall the ink cartridge according to the Operator’s Guide of Imprinter, and

then turn on the scanner again.

*3 Turn off the scanner. Reinstall the option board properly, and then turn on the scanner again.
*4 1.If any abnormality occurs, turn off the scanner once, and then turn it on again.

2.If doing this (step 1) does not improve the situation, press the

and

buttons, which are labeled

as “Paper thickness” on the operator panel, for at least 2 seconds. Write down two characters dis-

played between

and

Example: In this case, “14” is displayed on the panel.

3.According to section

“4.5 Cleaning the Transport path and the sensors” on page 114

, clean respective sen-

sors for each code as shown in the table below.

Code

Sensor Name

Supersonic sensor (three pieces in the upper and lower transport paths; respectively)

Pick sensor (one piece in the lower transport path)
Reflector for pick sensor (one piece in the upper transport path)

Skew sensor (six pieces in the lower transport path)
Reflector for skew sensor (six pieces in the upper transport path)

IMP top-sensor (one piece in the upper and lower transport paths; respectively)

RED top-sensor (one piece in the upper and lower transport paths; respectively)

REJ sensor (one piece in the upper and lower transport paths; respectively)

EXT sensor (one piece in the upper transport path)