FUJITSU fi-5950 - Manual (Page 212)

192
8.4 Multifeed Detection
5. Speficy the detection area.
Selected range: Add check mark to this checkbox first. The following setting becomes available.
Enable/Disable : Select [Enable], if the area from [Start] to [End] is a Multifeed detection area. Select
[Disable], if the area from [Start] to [End] is not a Multifeed detection area, but other
area is a Multifeed detection area.
Start : You can specify the starting position of the selected range by the length from the
edge of the paper document.
Range: 0 to 510mm, in increments of 2mm, Start position
End : You can specify the ending position of the selected range by the length from the edge
of the paper document.
Range: 0 to 510mm, in increments of 2mm, Start position
35 35 35
60 60
F
eeding direction
Left Middle Right
Document
Unit: mm
Detection areas