FUJITSU MCE3130AP - Manual (Page 152)

5 - 4 C156-E142-02EN
Figure 5.2 Inserting cartridge
5.1.4 Ejecting (removing) cartridge
Remove the cartridge as explained below.
(1) When the drive power is on:
1) The cartridge can be removed by pressing the eject button.
Notes:
1. If the command prevents ejection, the cartridge cannot be removed.
2. Remove the cartridge when completely ejected.
Note:
Even if the drive set-up conditions are met, note that the cartridge can drop from the drive after
ejection depending on the ambient environment and the cartridge's condition.
(2) When the drive power is off:
If the drive power is off, the cartridge cannot be removed by pressing the eject button. The
cartridge can be removed by insert the eject jig (accessory) or a pin (diameter: about 1 mm) into
the manual eject hole.
Notes
1) NEVER attempt to eject the cartridge while the BUSY LED lamp is on. The data may be
destroyed or trouble may result in the drive.
2) Note that the cartridge may drop from the drive when it is ejected.
Push by hand the width of 20mm to the
right and left from the cartridge rear
center, to the position shown at right. Shutter
Inserting direction