FUJITSU 32 - Manual (Page 95)

88
Note.
Depend on some scanner models, once the [Scanner Information] tab appears, the
operation panel is unable to be handled. In this case, close this dialog and turn the power
ON/OFF of the scanner. After the scanner setup, the operation panel is able to be handled.
When using a scanner, the following message may be displayed.
If this message appears, replace consumables following the instructions below.
< If replacing consumables immediately >
1. Check [This message not display again.]
2. In cases where consumables are replaced after completing all documents being scanned,
click [Ignore]. In cases where scanning is stopped for an immediate replacement, click
[Cancel].
3. Following the operator’s guide of the device, replace the consumables.
4. Select [Device setting] tab, click [Clear] button to reset the consumables counter.
< If replacing later (immediate replacement is impossible) >
1. If it is not necessary to display this message again, check [This message not display
again]*. If it is necessary to display this message again after scanning xxx pages, check
[Warns again after scanning xxx pages].
2. If the scanning is continued, click [Ignore] and close the message. If the scanning is
stopped, click [Cancel] and close the message.
3. Replace consumables as soon as possible or when this message appears next time.
4. After the replacement, click [Clear] of [Device setting] tab.
(* If [This message not display again] is checked, this message will not appear before the
consumable counter is reset.)
About Power saving
Specify when the lamp turns off. This is the elapsed time after a scan is complete.
* Depending on the scanner model, the range which can be set is different.