FUJITSU 32 User Manual

Page 106

width.

User response:

Adjust the imprinter so that the printing part is settled within the paper
width.

• A Hardware Alarm is detected in the Imprinter or Endorser option.

Cause:

Failure on Imprinter or Endorser.

User response:

Please check if the Imprinter or the Endorser is installed completely.

If the error occurs after checking the Imprinter or the Endorser, please
contact the retail store where the product was purchased or the nearest
service center.

• The Multifeed is detected.

Cause:

The papers are scanned with multifeeding. (One paper stuck to
another)

User response:

Remove the papers stopped by multifeeding, and reset them.

• Insufficient memory.

Cause:

Insufficient memory for scanning. The memory available may be
insufficient because an application consuming much GDI memory is
operating, too many other programs operate at the same time, or there
are too many registered device drivers. The user may mistakenly
think that adding more memory will solve this problem. However, in
most cases, memory shortage is due to insufficient conventional
memory (called the main memory within 640 kilobytes). Checking
CONFIG.SYS and AUTOEXEC.BAT may be a better solution.

User response:

Cancel the registration of device drivers that are irrelevant and make
sure that only the absolutely necessary programs are operating. Use
the memory optimization tool to allocate as much conventional
memory as possible.

• An error occurred in the temporary file.

Cause:

Accessing the internal temporary file of the scanned image is causing
the error. The disk space may be insufficient, the temporary file may
be damaged, or other programs may be affecting disk access.

User response:

Increase the free space of the disk. Check the hard disk (chkdsk and
scandsk). Make sure that no other program is accessing the disk. If
the error message persists, contact the retail store where the product
was purchased or the nearest service center.