FUJITSU 32 - Manual (Page 53)

46
If moving the density dial to the UP direction, the density changes [Normal] >>[Darker
scanning]>>[Dark scanning]. If moving the density dial to the Down direction, the
density changes [Normal]>>[Lighter scanning]>>[Light scanning]. If the dial is in the
center, the scanning density is [Normal].
− Enable [Duplex] button
This specifies whether the [Duplex] button (to switch simplex and duplex) on the
scanner operator panel is enabled.
And, it distinguishes whether to scan from the ADF, or from the Flat Bed (FB), and
changes automatically.
If this box is checked,
when a document is on the ADF, scanning is started from the ADF.
And when no document is on the ADF, scanning is started from the FB.
Scanning changes [Simplex] >> [Duplex]>> [Simplex] each time the [Duplex] button is
pressed.
− ADF/FB Automatic change
It distinguishes whether to scan from the ADF, or from the Flat Bed (FB), and changes
automatically.
When a document is on the ADF, scanning is started from the ADF.
And when no document is on the ADF, scanning is started from the FB.
− Enable [Send to] button
Specifies whether the preview is started by pressing the [Send to] button on the device.
− Enable FB Scanning Start
Specifies whether Scanning is started by closing the Flat bed cover.
When setting the document on the Flat bed and closing the Flat bed cover, scanning
starts.
− Enable [Scan] Button
Specifies whether scanning is started by the [Scan] button.