FUJITSU 32 - Manual (Page 105)

98
Cause: An incorrect value has been specified for the image scanner. The
problem may be due to an illegal combination with the specification
value from the application.
User response: Change the specification values. Then, try scanning again.
• Irregular status is detected in scanner..
Cause: A scanner fault such as a blown fuse or foreign matter in the scanning
section has occurred.
User response: ・ Restart the scanner.
・ Confirm the cable connection.
・ Clean inside of the scanner.
If the error persists, contact the retail store where the image scanner
was purchased or the nearest maintenance and service center.
• Anomaly in the command for communicating with the scanner.
• Anomaly in communication with the scanner.
Cause: The SCSI cable is not connected firmly or is disconnected.
User response: Confirm the cable connection.
If the cable is disconnected, replace the cable with new one.
If the error persists, contact the retail store where the image scanner
was purchased or the nearest maintenance and service center.
• Hardware Error was detected. Carrier motor/sensor was broken or Shipping Lock is
set in "Lock" position. Please refer to the user's manual for your scanner.
• Please confirm the shipping lock is unlocked.
Cause: The Shipping Lock may not be set in "Unlock" position.
User response: Check the Shipping Lock.
If the Shipping Lock is set in "Lock" position, set the Shipping Lock
in "Unlock" position referring to the user's manual for your scanner.
• Ink cartridge is not installed in the imprinter properly. Please check the installation
and try again.
Cause: The imprinter (Endorser) has no ink cartridge or the ink cartridge may
be mounted improperly.
User response: Check that the ink cartridge of the imprinter is mounted properly and
scan again.
• Imprinting position is set out of paper. Please check the imprinting position and try
again.
Cause: Printing is not available because the printing part is outside the paper