FUJITSU 32 User Manual
Page 110
103
8.1.3. Messages concerning to FUJITSU Scanner Control Center
• Failed to start-up the application. Check the setting of FUJITSU Scanner Control
Center.
• The setting of the path is blank. Check the setting of FUJITSU Scanner Control
Center.
• Can not find the specified file. Check if the specified path and file name is correct.
• Can not find the specified work folder. Check if the specified path is correct.
Cause:
The setting of the application may be inadequate.
User response:
Check setting items of [General] in [Application Dialog] and make
sure settings are correct and there is no omission. If you find any
incorrect setting or omission, correct it.
• The same Plug-in has been installed already. Specified Plug-in can not install.
Cause:
An attempt was made to install the same plug-in that has been already
installed.
User response:
Two or more plug-ins assigned to the same name cannot be installed.
• The specified file is not the effective plug-in. Specified file can not install.
• Can not find the entry point of the specified plug-in. Specified file can not install.
Cause:
The specified file may not be the effective plug-in.
User response:
Check whether the specified file is the effective plug-in and retry.
• Exceeded the number of plug-in to be supported. Can not install the new plug-in.
Cause:
The number of plug-ins to be supported was exceeded.
User response:
The maximum number of plug-ins that can be supported is 50. Delete
unnecessary plug-ins in the folder where FUJITSU Scanner Control
Center has been installed, then install another plug-in.
• The plug-in has not been installed.
Cause:
The check box "Use a Plug-In" was checked but no plug-in has been
installed.
User response:
To use a plug-in, install a plug-in, then check the check box "Use a
Plug-In."
• Can not find the application for the Plug-in use. Can not use the specified plug-in
Cause:
The application to be used for the plug-in may not have been installed.
User response:
Verify that the application to be used for the plug-in has been
installed. If no application is found, install it.