FUJITSU 32 - Manual (Page 41)

34
Use Both Memory
Pre-reads using memory of both Scanner and PC (displayed only if supported by the
scanner).
♦ Batch
Detection
The application can detect documents on a specific type of form (special paper). The
application must support this function.
None
No detection. Scanning is done without change.
Include and Continue
After the special paper is detected, scanning continues. The data on the special paper is
also valid.
Include and Stop
After the special paper is detected, scanning stops. The data on the special paper is also
valid.
Exclude and Continue
After the special paper is detected, scanning continues. The data on the special paper is
excluded and will not be transferred to the application.
Exclude and Stop
After the special paper is detected, scanning stops. The data on the special paper is
excluded and will not be transferred to the application.
This option may not be supported for some scanners. See "Relevant Image Scanner
Specification" in the Appendix.
♦ Multifeed Detection
This option detects a multifeed (occurs when two or more documents are sent) based on the
set condition.
If a multifeed is detected when this setting has been turned on, the device will stop and an
error message output.
None
Multifeed detection is not performed.
Hardware Setting
A multifeed is detected based on the device setting.
Check thickness
The thickness of the transmitted document is checked by the sensor in the device.
A multifeed is detected by detecting changes in the thickness when more than one
document is sent.