FUJITSU 32 - Manual (Page 103)

96
User response: Enter the filename of the setting file. Then, try scanning again.
• Specified string is too long.
Cause: The specified string is too long. Up to 128 en-size characters and up
to 64 em-size characters can be specified.
User response: User response: Reduce the number of characters in the string so that
they do not exceed 128 en-size characters. Then, try scanning again.
• Cannot specify next words for filename. \:;?”<>
.
Cause: The specified filename contains one or more of the following
characters: \:;?”<>
.
User response: Enter a file name that does not contain the above characters. Then,
make the settings again.
• The image scanner not found.
Cause: Possible causes include the following: an image scanner that is not
supported by this driver has been connected, no image scanner has
been connected, or the cable is not connected.
Otherwise, the initial values of the image scanner were overwritten
while the driver was open.
User response: Check the connection of the image scanner.
Check the scanner is not used by other application.
• The specified image scanner is being used.
Cause: The image scanner may be already in use by another application, or
the TWAIN driver may have been started twice.
User response: User response: After all applications are terminated, restart the image
scanner for scanning.
• An input-output error occurred in the image scanner.
Cause: A fault occurred during the scan operation of the image scanner.
There may be a fault in the image scanner itself.
User response: Turn off the power of all devices, then turn on the power of the
computer before turning on the scanner and retry scanning. If the
error still occurs, contact the retail store where the image scanner was
purchased, or the nearest service center.
• Scanner is turned OFF. Data source processing is closed. Turn ON the scanner and
re-scan.
Cause: Scanner may be turned OFF during scanner use.