ATL Telecom AM2 - Manual (Page 90)

ATL User Guide
AM2 G.SHDSL Modem 90
You can delete the user by number using the clear command. If you are not sure of the number of users, you
can use the list command to check it. Modify command is to modifies an old user information or adds a new
user to the user profile.
To modify or add a new user, move the cursor to the modify command and press the enter key.
Command: admin user modify <1~5>
Message: Please input the following information.
Legal access user profile number <1~5> :
The screen will prompt as follows.
>> Attrib UI mode
Profile User name and password
There are two UI modes, command and menu mode, to setup the product. We will not discuss the command
mode in this manual.
Security
The security command can be configured for sixteen legal IP addresses for telnet access and telnet port
number. Move the cursor " >> " to the security command and press the enter key. The default legal address
is 0.0.0.0. It means that there is no restriction on IP addresses to access the modem via the telnet.
>> port Configure telent TCP port
ip_pool Legal address IP address pool
list Show security profile
SNMP
Simple Network Management Protocol (SNMP) is the protocol not only governing network management, but
also monitoring network devices and their functions. The AM2 can generate SNMP traps to indicate alarm
conditions, and it relies on SNMP community strings to implement SNMP security. This unit also supports MIB
I & II. Move the cursor " >> " to the snmp command and press the enter key. The following sub-menu will
be displayed.
>> community Configure community parameter
trap
Configure trap host parameter