ATL Telecom AM2 - Manual (Page 70)

ATL User Guide
AM2 G.SHDSL Modem 70
7.3.2.1 SETUP
All of the configuration parameters for the AM2 are located in this menu. From the enable menu, move
cursor " >> " to the setup command and press the enter key .
The screen will now display the following sub-menu.
>> mode Switch system operation mode
shdsl Configure SHDSL parameters
wan Configure WAN interface profile
bridge Configure transparent bridging
vlan Configure virtual LAN paramters
route Configure routing parameters
lan Configure LAN interface profile
ip_share Configure NAT/PAT parameters
firewall Configure Firewall parameters
dhcp Configure DHCP parameters
dns_proxy Configure DNS proxy parameters
hostname Configure local host name
default Restore factory default setting
enable The enable option allows the user to modify the current user privilege
setup The setup option allows the user to configure the modem
status The status opyion displays the current status of the modem
show The show option displays the current hardware and software configuration
s
write The write option allows the user to write the new configuration to the FLASH
COMMAND DESCRIPTION
reboot
ping
admin
utility
exit
The reboot option allows the user to reboot the modem using the last saved
configuration
The ping option allows the user to test the LAN connection by using the Packet
InterNet Groper (PING) command
The admin option allows the user to setup the user and supervisor security and
password
The utility option allows the user to update the software
The exit option allows the user to exit the modem command line interface