ATL Telecom AM2 - Manual (Page 89)

ATL User Guide
AM2 G.SHDSL Modem
89
Type in the IP address of the LAN connection you wish to test and press the enter key. The following message
will be displayed.
Number of ping request packets to send (TAB select):
There are three options. You can scroll through the options by pressing the TAB key,
Default - sends 4 request packets
1~65534 - Allows the user to set the number of packets. If this option is selected the display will prompt you
to enter the number of packets from 1 to 65534.
-t - Sends an unlimited number of packets. The test is terminated by pressing CTL+C
Once you have selected the required number of packets, press the enter key. The following message will be
displayed
Data size [1~1999]:
This allows the user to enter the size of the data packet (bytes). Once you have entered the data size, press
the enter key. The AM2 will now perform the required ping test and display the result
7.3.2.7 ADMIN
You can modify the user profile, telnet access, SNMP (Simple Network Management Protocol), supervisor
information and SNTP (Simple Network Time Protocol) via the admin command. To configure the parameters,
move the cursor " >> " to the admin command and press the enter key. The following sub menu will be
displayed
>> user Manage user profile
security Setup system security
snmp Configure SNMP parameter
passwd Change supervisor password
id Change supervisor ID
sntp Configure time synchronization
User
You can use the user command to clear, modify and list the user profile. You can set up to five users to access
the modem via the console port or telnet in user profile table, however users who have the supervisor
password can change the configuration of the modem. Move the cursor " >> " to the user command and
press the enter key. The following sub-menu will be displayed.
>> clear Clear user profile
modify Modify the user profile
list List the user profile
7