ATL Telecom AM2 - Manual (Page 28)

ATL User Guide
AM2 G.SHDSL Modem 28
6.4.5.2 AT THE CPE UNIT
The following outlines the steps that need to be followed to setup the unit as a CPE Route unit.
6.4.5.2.1 STEP 1
From the options displayed, select the Route and CPE Side options. Then click on the Next button
6.4.5.2.2 STEP 2
On the next screen, type in the IP Address, Subnet Mask and Host Name. You also need to decide if the DHCP
Service needs to be set to enable or disable. For the example shown the following details should be entered.