ATL Telecom AM30 - Manual (Page 15)

ATL Telecom User Guide
AM30
1
5
Quick Start
This Quick Start provides basic instructions for connecting the ROUTER to a computer or
LAN and to the Internet.
fPart 1 describes setting up the hardware.
fPart 2 describes how to configure Internet properties
on your computer(s) and how to install the software
for using a computer attached to the USB port.
fPart 3 shows you how to configure basic settings on
the ROUTER to get your LAN connected to the
Internet.
After setting up and configuring the device, you can follow the instructions on page 32 to
verify that it is working properly.
This Quick Start assumes that you have already established ADSL service with your Internet
service provider (ISP). These instructions provide a basic configuration that should be
compatible with your home or small office network setup. Refer to the subsequent chapters
for additional configuration instructions.
Part 1 — Connecting the Hardware
In Part 1, you connect the device to the phone jack, the power outlet, and your computer
or network.
WARNING
Before you begin, turn the power off for all devices.
These include your computer(s), your LAN hub/switch (if
applicable), and the ROUTER.
Figure 4 illustrates the hardware connections. The layout of the ports on your device may vary
from the layout shown. Refer to the steps that follow for specific instructions.