IDEC WindSRV - Manual (Page 35)

34
www.kepware.com
KEPServerEX5 Help
11 Calling
19 Answering
Last Event Values
LastEvent Reason for Change
-1 [no events have occurred yet]
0 Initialized with TAPI
1 Line closed
2 Line opened
3 Line connected
4 Line dropped by user
5 Line dropped at remote site
6 No answer
7 Line busy
8 No dial tone
9 Incoming call detected
10 User dialed
11 Invalid phone number
12 Hardware error on line caused line close
Last Event String Values
LastEvent StringLastEvent
-1 [no events have occurred yet]
0 Initialized with TAPI
1 Line closed
2 Line opened
3 Line connected
4 Line dropped by user
5 Line dropped at remote site
6 No answer
7 Line busy
8 No dial tone
9 Incoming call detected
10 User dialed
11 Invalid phone number
12 Hardware error on line caused line close
13 Unable to dial
Communications Management
Auto-Demotion
The Auto-Demotion parameters allow a driver to temporarily place a device off-scan in the event that a device is not
responding. By placing a nonresponsive device offline, the driver can continue to optimize its communications with
other devices on the same channel by stopping communications with the nonresponsive device for a specific time
period. After the specific time period has been reached, the driver will re-attempt to communicate with the
nonresponsive device. If the device is responsive, the device will be placed on-scan; otherwise, it will restart its off-
scan time period. See Also:
Device Properties - Auto-Demotion .
Network Interface Selection
Users can select a NIC card for use with any Ethernet driver or serial driver running in Ethernet Encapsulation mode.
The Network Interface feature is used to select a specific NIC card based on either the NIC name or its currently