IDEC WindSRV - Manual (Page 147)

146
www.kepware.com
KEPServerEX5 Help
The IP address that is specified for a device on an Ethernet Encapsulated channel is not a valid IP address.
Solution:
Correct the IP in the XML file and then re-load the project.
Note:
This error occurs when loading XML formatted projects. These projects have usually been created or edited with a third
party XML software.
Invalid or missing Modem Configuration on channel '''
Error Type:
Warning
Source:
Configuration
Possible Cause:
A server project was loaded that uses a modem unavailable on this PC.
Solution:
1. Change the Modem Configuration in the project to use a supported modem.
2. Add the specified modem to the PC's Configuration.
Invalid XML document ''
Error Type:
Error
Source:
Configuration
Possible Cause:
The server attempted to open a project formatted with XML and was unable to parse the XML file.
Solution:
If the server project was edited using a third party XML editor, verify that the format is correct via the schemas for the
server and drivers.
Maximum channel count exceeded for the lite version '' driver license
Error Type:
Warning
Source:
Configuration
Possible Cause:
The specified driver was activated with a lite license, which limits the number of channels that can be configured.
Solution:
1. Verify the number of channels authorized by the license. Then, correct the project design to use only that number of
channels.
2. If more channels are needed or the lite activation is incorrect, contact the sales representative about upgrading the
license to a version that will support the number of desired channels.