IAI America RCM-E - Manual (Page 70)

62
Appendix
* Appendix
Parameter (factory-installed) initializing method
Parameter is changed to the factory-installed parameter. (Initialization)
Models of PCON, ACON, SCON, ERC2 are available for this method.
Caution: Note that the parameter set by the user is changed to the factory-installed parameter if the
parameter (factory-installed) is initialized.
(Note) Unless the software was reset, the parameters were rewritten to factory-installed
parameters, however, operation is not performed with factory-installed parameters.
The parameters are enabled after the next reset or after power is turned on.
Slct Mode/M2 A. 00
* User Adjust
In the mode select screen, using the keys,
set the user adjustment, and then press the Return
key.
User Adjust A. 00
Adjust 5119
Input 5119 into the adjustment number, and press the
Return key.
Ship Para A. 00
* Reset? Y Æ 1 N Æ 0
When initializing the parameter (factory-installed),
press the
key.
When initialization of the parameter (factory-installed)
is completed, the screen moves to the software reset
screen. (When interrupting, press the
key. The
screen returns to the mode select screen.)
Soft Reset A. 00
* Reset? Y Æ 1 N Æ 0
When executing software reset, press the key.
(When interrupting the software reset, press the
key. The screen returns to the mode select screen.)