InFocus Laser Platform M-300 - Manual (Page 76)

6-12 Sample Materials
DELRIN (SEAL PRESS)
RASTER ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
15 100 18 500 1 .015”
20 100 23 500 1 .015”
25 100 29 500 1 .015”
30 100 35 500 1 .015”
35 100 41 500 1 .015”
40 100 47 500 1 .015”
45 100 53 500 1 .015”
50 100 58 500 1 .015”
VECTOR CUTTING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
15 75 1.2 200 1 .060”
20 75 1.6 200 1 .060”
25 75 2.0 200 1 .060”
30 75 2.4 200 1 .060”
35 75 2.8 200 1 .060”
40 75 3.2 200 1 .060”
45 75 3.6 200 1 .060”
50 75 4.0 200 1 .060”
COMMENTS
The laser system can be used to make dies
for seal presses. It can engrave and cut out
a typical Notary Seal in less than 5 minutes.
Create the male with a white graphic and a
black background. Mirror the image and
invert it by making the background white and
the graphic black. Add a .010 inch black
outline to the graphic portion of the female
side. This will give the greater clearance to
the female side to prevent the paper from
piercing through when the male side of the
seal presses into the female side. Once the seal is made and fastened to the press, make
several impressions onto 400 grit sandpaper to smoothen out the edges of the plastic. Make
sure you turn the sandpaper over to get both sides of the seal.
LASER CUTTING THIS MATERIAL CAN CAUSE FLAMING. Use caution
when attempting to cut this material. Make sure that the flame does not come
in contact with any part of the laser system. NEVER leave the machine
unattended while processing any material. Damages caused by processing
any material WILL NOT be covered under warranty.
MALE FEMALE