InFocus Laser Platform M-300 - Manual (Page 60)

Options & Accessories 5-5
In the laser systems printer driver, use the same settings as the previous example but with only
minor modifications. In the “3D Effects” tab, select all three “Special” options; “Add Shoulder”,
“Print as Negative Image” and “Print as Mirror Image” as the diagram below illustrates.
Print to the laser system. Position the full sheet of rubber stamp material in the same upper left
location on the engraving table and begin engraving. The driver automatically adds the shoulder,
mirrors the entire page, and creates a negative image for engraving, and cuts out the stamps.
Rotary Fixture
The Rotary Fixture has been designed to engrave cylindrical objects. Two attachments come
with the fixture, a cone shaped disk attached to the motorized end of the fixture and an inverted
cone shaped disk attached to the adjustable end of the fixture. These attachments are used to
hold wineglasses, mugs, cups, etc.