InFocus Laser Platform M-300 - Manual (Page 31)

3-6 System Operation
The “NEXT FILE” button displays the next file in the systems memory and makes it the current
file and will stop at the last file in memory. The “PREV FILE” button displays the previous file in
the systems memory and makes it the current file and will stop at the first file in memory. These
buttons are inoperative if a file is currently running.
The Motion Control System
The motion control section of the control panel (the four directional arrow buttons) enables the
user to manually control motion system movement.
Pressing and holding down an arrow button will cause the focus lens assembly to move in the
respective direction. The motion system starts off slowly, but if you continue to hold down the
button, you will see it accelerate to a faster speed. Pushing the button once and letting it go
quickly will move the motion system in .001 inch increments. Pressing two adjacent buttons will
move the assembly in a diagonal direction. This part of the control panel is primarily used to
position the focus lens assembly directly over the engraving material and to use the focus tool to
set the proper focus height. Other uses for these buttons will be discussed later in this manual.
You must be in the “FILE DISPLAY” menu or the “MAIN” menu for this button to be operable.
Pressing it enables the “ORIGIN POSITION” menu to appear. It also turns on the optional red
laser diode that shows where the focus lens assembly is positioned in the field by shining a
bright red “dot” on the engraving area. Further details on how to use this button will be covered
later in this section.
This button positions the focus carriage slightly away from the upper left hand corner at the
default (1,1) position in the engraving area. This is where the majority of focusing will be done.
Once the focus carriage is positioned, using the motion control arrow buttons can still move the
motion system. Pressing the button again will move the focus carriage back to the home
position in the upper right corner of the engraving area. You can set the default position to
anywhere in the field that you desire. Relocating the focus position is covered later on in this
section.