InFocus Laser Platform M-300 - Manual (Page 103)

When running the laser system,
the laser system will “freeze”, the
clock will keep advancing, but
the operator will have no control
over the system. The only way to
restore the system is to power
the laser off and then back on.
This is a symptom of file
corruption. • Incorrect BIOS setting in computer
• Using a printer cable longer than 6 ft.
• Bad printer cable
• Usage of device in between computer
and laser system
• Some other parallel port driver
interfering with the laser system printer
driver
• Damaged port in CPU
• Refer to manual on proper setting
• Use only a 6 ft., IEEE1284 compliant
printer cable
• Replace printer cable
• Connect the laser system directly from
computer with the printer cable
• Remove all other parallel port drivers
and try again
• Replace laser system’s CPU
Ihr ULS Vertragshändler :
MarkIDent GmbH
Winterspürerstr. 19
78333 Stockach
www.markident.de