InFocus Laser Platform M-300 User Manual
Page 19
2-6
Installation
9. Note the lifting points as shown. With
the assistance of one or two other
people, carefully lift the laser system and
place it onto the cart assembly being
careful not to drop it or pinch your
fingers.
10. Thread the remaining two screws and
lockwashers (C) through the tabs on the
back panel (A) and into the backside of
the laser system. Do not tighten down
completely yet.
11. Thread the 4 screws and flat washers
(H) through the underside of the legs and
into the bottom of the laser system. Do
not tighten down completely yet.
12. Gently open the front door and see if it
comes in contact with the bottom part of
the legs.
13. Space the legs apart to provide
clearance for the front door.
14. Securely tighten all remaining screws
(C) and (H).
15. Relocate the laser system to its final
resting position next to the computer and
exhaust system.
16. If the floor underneath the laser system
is uneven, the casters must be adjusted.
Refer to the following leveling
instructions. Place a bubble level across
the top of the legs directly above the front
casters. Note the bubble position in its
sight glass. Do the same for the back
part of the legs and also note the position
of the bubble in the sight glass. If the
bubbles are in the same visual position,
adjustment is not necessary and cart
assembly is complete. If they are in different positions, adjustment is required.
17. To adjust the casters, choose ONLY ONE (1) caster and adjust its height until both bubbles
are visually identical between the front casters and the back casters. The purpose of this
step is to make sure that all casters lie in the same plane, not to level the laser system with
the ground. If desired, you can level the laser system with the ground although it is not
required.
18. Open the top door and remove the rubber band that is holding the arm in place.
19. Remove any remaining packing materials, accessories or any other items that may be
located inside the cabinet or on top of the engraving table.
20. Gain access to the rear of the laser system to install the Laser Cartridge.
LIFT HERE
(SAME FOR OTHER SIDE)
Adjust spacing if front door
comes in contact with legs.
BU
BBL
E LE
VE
L