InFocus Laser Platform M-300 - Manual (Page 28)

System Operation 3-3
“Wattage” signifies the amount of heat energy that the laser light is producing over a period of
time. Laser energy is measured with a laser power meter. Do not confuse the electrical
wattage rating of a light bulb or a hair dryer with the wattage rating of the laser system. They are
two different types of measurements.
Motion System
The motion system consists of the mechanically moving parts of the laser system. It is made up
of rails, motors, bearings, belts, mirrors, a lens, and other parts. There are two directions of
motion, left and right is called the “X” direction and front to back is called the “Y” direction.
The CPU controls the movement of the motors, which moves the mirrors and focus lens across
the engraving area and over the material. At the same time, it is synchronizing the laser pulses
with the position of the focus lens. It is this precise positioning and timing of the laser pulses that
produces the highest quality and fastest speed of engraving.
In summary, the five (5) components work together to take the graphic image that is downloaded
to the laser system from your computer and burn it into the material located on the engraving
table inside of the laser system.
The Control Panel
The control panel on the laser system provides easy access to all of the controls necessary for
cutting and engraving operations. The control panel consists of a liquid crystal display (LCD),
indicator lights, and selection buttons. The following section will describe, in detail, how to
maneuver through the menu system and the significance of each item in the control panel.