InFocus Laser Platform M-300 - Manual (Page 61)

5-6 Options & Accessories
The Rotary Fixture is placed on the engraving table as the following diagram illustrates.
Please refer to the instructions supplied with the Rotary Fixture on how to properly install and
use this option.
Cutting Table
The purpose of the Cutting Table is to support the material that you are cutting off of the
engraving table’s surface to minimize surface contact area. It also redirects exhaust airflow
below and above the material for better smoke removal. The Cutting Table is installed directly on
top of the engraving table. It is composed of a sheet metal box, alignment rulers, and a
replaceable honeycomb style bed. The honeycomb material is reflective only in the area that
contacts your material to minimize laser beam reflection.
Please refer to the instructions supplied with the Cutting Table on how to properly install and use
this option.