HP DX2000 - Manual (Page 48)

6–6 359782-002 Service Reference Guide, dx2000 uT
Removal and Replacement Procedures— Microtower (µT) Chassis
6.5 Memory
For more information on the memory in this series of computers, refer to Appendix E,
“Memory.”
6.5.1 Installing Memory Modules
Ä CAUTION: The memory module sockets have gold metal contacts. When upgrading the memory, it is
important to use memory modules with gold metal contacts to prevent corrosion and/or oxidation
resulting from having incompatible metals in contact with each other.
Ä CAUTION: Static electricity can damage the electronic components of the computer or optional cards.
Before beginning these procedures, ensure that you are discharged of static electricity by briefly
touching a grounded metal object. Refer to Chapter 5 for more information.
Ä CAUTION: When handling a memory module, be careful not to touch any of the contacts. Doing so
may damage the module.
1. Prepare the computer for disassembly ( Section 6.1, “Preparation for Disassembly” ).
✎
If there is a hard drive in bay 5 it will be necessary to remove the lower drive cage before
removing the memory modules (
Section 6.7.4, “Removing the Lower Drive Cage” ).
2. Remove the right access panel ( Section 6.2, “Access Panel” ).
Å WARNING: To reduce risk of personal injury from hot surfaces, allow the internal system components
to cool before touching.
3. Lay the computer down on its side to make it easier to work on.
4. Open both latches of the memory module socket 1, and insert the memory module into the
socket 2. Begin by installing a module into the socket nearest the preinstalled module, and
install the modules following the numerical order of the sockets.