HP DC7800 User Manual

Page 180

Text mode
Original mode

If you are adding a second SODIMM, remove the SODIMM from the top DIMM1 socket to access
the bottom DIMM3 socket. Press outward on the two latches on each side of the SODIMM (1) then
pull the SODIMM out of the socket (2).

Slide the new SODIMM into the socket at approximately a 30° angle (1) then press the SODIMM
down (2) so that the latches lock it in place.

NOTE:

A memory module can be installed in only one way. Match the notch on the module with

the tab on the memory socket.

A SODIMM must occupy the DIMM1 (top) socket.

Replace the SODIMM in the DIMM1 socket if it was removed.

The computer automatically recognizes the additional memory when you turn on the computer.

168 Chapter 9 Removal and Replacement Procedures Ultra-Slim Desktop (USDT) Chassis