HP 480-0005-00-15 - Manual (Page 72)

P/N 480-0005-00-15 3-9
Chapter 3: Installation
Connect to PC Console (with System Controller)
You will need to connect the Tenor CMS chassis to your workstation’s serial port via RS-232 connection.
(This connection will be used when you assign an IP address to the chassis. The instructions below assume
you are connecting to a PC).
NOTE: For illustration purposes, the CMS (14 Slot) AC unit is shown
Figure 3-6 Connect to PC Com
NOTE: You must use a null modem cable with a DB-9 male connector (see section Chapter 2: Hardware
Components for pinouts) to connect the System Controller card to a PC as follows:
1. Insert the male end of the DB-9 cable (yellow cable if provided by Quintum) into the System Controller
card’s port labeled Console. (See Chapter 2: Hardware Components for RS-232 connector pinouts.)
2. Insert the female end of the DB-9 cable into your workstation’s serial port (see your PC documentation for
more information about this port).
DB-9
Multi-Path Voice Gateway
TM T ECHNOLOGIES, INC. QUINTUM Anoth er Fine P roduct From
0 1 Re se t +3 .3 V +5V +12 V -1 2 V
QUINTUM TECHNOLOGIES, INC.
Console
ABT B FL CPU CPCI PCI .2 9 5 .5 3 1 TM QUINTUM TECHNOLOGIES, INC.
QUINTUM TECHNOLOGIES, INC.
TM TM System Control ler
RS T
Fault Fault
10/100 E thernet
Tenor CMS QUINTUM T ECHNOLOGIES, INC. © Copyright 2001 Q uintu m Technologies Inc.
TM TM
Gro und Strap
TM
Hot Swa p DS1
Sta tus Alarm
1 2 P CI CPU
Ba nk DSP 1 2 TX/RX Li nk
1 2 3 4
5 6 7 8
10/100 Eth ernet
Span
Status
TECHNOLOGIES, INC. QUINTUM TM
Tenor CMS Q UINTUM TECHNOLOGIES, INC. © Copyright 2001 Quintum Technologies Inc.
Chassis Front
Console
ABT
BFL CPU
CPCI PCI .295 .531
TM
RST
10/100
Ethernet