HP 480-0005-00-15 - Manual (Page 69)

3-6 P/N 480-0005-00-15
Chapter 3: Installation
Connect to Line Interface - PBX
The instructions which follow tell you how to connect a red RJ-48 cable between the PBX and the TI/E1/DS1
card. See Chapter 2: Hardware Components for a list -of RJ-48 cable pinouts you can use to make a custom
cable.
NOTE: For illustration purposes, the DC unit is shown with a DS1 card.
Figure 3-3 Connect to Line Interface
Connect to Line Interface as follows:
1. Plug one end of the crossover RJ-48 cable into one of the eight WAN E1 or T1 ports on the rear of the tran-
sition modules. This cable from Quintum would be the red RJ-48 crossover cable. See Chapter 2: Hard-
ware Components for cable pinouts if you are making your own cables.
2. Connect the other end of the crossover RJ-48 cable into the appropriate port on the PBX. (If another cable
or adapter is required, see Chapter 2: Hardware Components for RJ-48 crossover pinout information.
NOTE: If you are connecting to an external CSU, ensure the Digital Interface is configured as short haul (or
DSX-1), otherwise, configure the Digital Interface to DS-1 to enable the built in CSU via Com-
mand Line Interface (CLI). See Chapter 4: Getting Started with Command Line Interface (CLI).
10
1
2
3
4
DS1
1
2
3
4
10/100
Ethernet Link TX/RX
Link TX/RX
1
2
3
4
Console
Config 1
2 3 4
10/100
Ethernet
Link TX/RX 1 2 3 4
CPU
Off On
Off On 0 1
Off On 0 1 © Copyright 2001 Quintum Technologies Inc.
-48 |RTN| -48 |RTN| -48 |RTN| -48 |RTN|
Chassis Rear PBX
RJ-48 Crossover