HP 20-Feb - Manual (Page 45)

Chapter 1 Connecting and Powering on the Library 43
Cha
pter 1
f. Connect the Fibre Channel cable(s) to the host, hub, or switch. If
necessary, connect the Fibre Channel cable to the GBIC provided
before connecting to the host, hub, or switch.
Figure 21 Connecting Fibre Channel Cables to the GBIC
Caution The Fibre Channel printed circuit boards may contain a laser
system (GBIC or GLM module) that is classified as a “Class-I
Laser Product” under a U.S. Department of Health and Human
Services (DHHS) Radiation Performance standard according to
the Radiation Control for Health and Safety Act of 1968 and
EN60825-1(+A11) safety of laser products. The compliance
statement is located on the module.
6. Power on the hub or switch (if present).
Note The AC power cord is the library’s main AC disconnect device
and must be easily accessible at all times.