Harman Stove Company P35I - Manual (Page 31)

31 Pellets or Corn/Pellet Mixture Only
P35i Fireplace Insert
Save These Instructions 3-90-775R15_04/13
Warning! risK of fire! Keep combustible
materials, gasoline and other flammable vapors and
liquids clear of the appliance.
• Do
NOT store flammable materials in the vicinity of
the appliance.
• Do NOT use gasoline, lantern fuel, kerosene,
charcoal lighter fluid or similar liquids to start or
"freshen up" a fire in this appliance.
Keep all such liquids well away from the heater while it
is in use, as combustible materials may ignite.
Warning! risK of fire!
Do
NOT store fuel:
• Within the required clearance areas of the
appliance.
• Within the space required for fueling or ash
removal.
5. Cleaning Area Beneath Burn Pot Grate
• Frequency: Monthly or more frequently depending
on fuel quality and/or ash buildup.
• By: User
loosen the two wingscrews
on the front of the burn pot.
lift the cover off of the
wingscrews.
5. Cleaning Heat Exchanger & Exhaust
• Frequency: Monthly or after each ton of fuel is
burned.
• By: User
It is recommended that you use a vacuum that is
designed for ash, as ashes may block conventional
vacuum filters.
NOTICE: For optimal performance of your pellet
burning appliance, you must perform regular cleaning
and maintenance as directed in this manual. Not doing
so will result in:
Poor performance
Smoke spillage into the room
Overheating of components
Failure to perform regular cleaning on your pellet
burning appliance will void the warranty.
a. Make sure the fire is out and cool. Disconnect power
cord prior to servicing.
b. Scrape the majority of ashes into the ash pan. Begin
with the back and roof above the burn pot.
c. Scrape the ashes from both sides, into the ash pan.
a. Loosen the two wingscrews located on the front of
the burn pot housing.
b. Lift the cover off of the wingscrews and set aside.
c. Using your ash-vac, remove any ashes or debris
from the air chamber.
d. You can tap on the igniter, located above the cleanout
hole. This will help to remove any accumulation on
the igniter element.
e. Re-install the cleanout cover and tighten the
wingscrews. Be sure that the cover is completely
covering the hole, as air leakage here may lead to
incomplete combustion or poor ignition.