Harman Stove Company P35I - Manual (Page 19)

19 Pellets or Corn/Pellet Mixture Only
P35i Fireplace Insert
Save These Instructions 3-90-775R15_04/13
C. Routing the Power Cord
When choosing an electrical supply outlet, be sure
the polarity is correct, and that the supplied voltage is
within the range of 117 to 123 Volts. Surge protection
is also recommended to protect the control board
software in the event of a surge or spike.
Once the outlet location is decided, you'll need to
install and route the power cord.
At the bottom of each of the side surround panels is a
knockout for the cord retainer. Remove the appropriate
knockout and feed the loose wire end of the cord into
the hole. If your cord needs to
exit from the right side, route
the cord up the side and over
the top of the mounting frame
and back down the left side.
Attach the ground wire ring
terminal to the bottom stud
on the left, and use the two
hooks on the top corners of
the mounting frame to secure
the cord. Slip the cord clamp
onto the cord right in front of
the opening in the side panel.
Using a pliers, compress the
cord clamp and push it into the hole.
B. Installing the Surround
The surround consists of three panels, the top and two
sides. Follow these steps for installation:
1. Remove the insert body from the mounting frame;
2. Start your leveling bolts into the floor of the frame
and adjust to slightly raise the height.(see next
section) This will allow some clearance toassemble
the surround.
3. Prepare the side panels by removing three nuts
each. The left side panel is the one with the control
board opening. If mounting the control door, the
hinge bracket will attach using the control panel
mounting screws.
WARNING
ROUTE POWER CORD AWAY FROM THE APPLIANCE.
DO NOT RUN THE CORD UNDER OR IN FRONT OF
THE APPLIANCE.
Surround Splice
Plate
Control
Mount
Brackets
Control door
and hinge
Three nuts to
secure to the
frame.
4. Attach the side panels to the mounting frame by
guiding the threaded studs through the holes in
the mounting frame. Slip the power cord ground
wire terminal over the bottom stud on the left side.
Install the nuts onto the studs, finger tighten only.
5. Install the top panel, making sure to close the gap
with the side panels first. Tighten the nuts on the
splice brackets securely.
6. Set the mounting frame into position in the fireplace
opening. Be sure the surround panel is raised
slightly so that it is not supporting any of the weight
of the mounting frame.
7. When pleased with the alignment, tighten all of the
nuts securely.
8. There are two more holes in the splice brackets to
align the outer sides of the surround panel joints. If
desired, install the supplied black pop-rivets here.