HP sv6 - Manual (Page 76)

installation and user information
stereo hardware installation
Chapter 2 76
Connect power supply transformers to their respective emitters at
this stage. As with all computer equipment, emitters should be
surge-protected from hazardous power spikes wherever possible.
CAUTION It is recommended that all emitters be powered OFF when
connecting or disconnecting their cables to any other equipment.
This can reduce the possibility of harmful power surges to other
equipment when handling this signal source.
5. Power up the emitters
The power switch for emitters is located on the back side of the
device. The switch has three positions -- high, off, and low power. It is
recommended that you use the high power position to improve signal
performance, especially in rooms with high ambient light or that
accommodate larger audiences.
changing to stereo monitor mode
Use the following instructions to change graphics cards and compositor
settings to a stereo mode.
1. Add ScreenOption
log in to the master system as root
init 2
In addition to the SlsdVideo resolution settings or the videotiming
file specified in
/etc/X11/X0screens , add one of the following lines
under the ScreenOptions section:
SlsdCompositorStereo Active
SlsdCompositorStereo Passive
Save the /etc/X11/X0screens file
2. Start up the new X server:
init 3
This will set all graphics cards in the configuration to the new stereo
setting and then bring up CDE.