HP sv6 - Manual (Page 14)

safety and support information
safety warnings
Chapter 1 14
safety warnings
WARNING An hp visualization sv6 product rack can weigh 1500 lbs. (681 kg)
when fully loaded with hardware components. Heed all of the
conditions in the WARNING statement under the RACK
STABILITY subsection below when moving and servicing an HP
product rack and its rack-mounted hardware components.
WARNING Your hp visualization center sv6 product may not have been
evaluated for connection to an IT power system (an AC
distribution system having a high impedance connection to
earth according to IEC 950).
rack stability
WARNING To reduce the risk of rack instability:
• Install the heavier hardware components at the bottom of the
rack, below the center of gravity for the rack. Never install
heavier components in the top or upper portion of the rack.
• Make sure that the anti-tip plate is installed on the rack. Do
not remove the anti-tip foot from the rack.
• Always extend the anti-tip plate before extending a
rack-mounted component for servicing.
• Extend only one rack-mounted component at a time.
• Do not stand or sit on any extended component.
• Have all non-operator servicing done by qualified HP service
personnel.