HP sv6 - Manual (Page 20)

installation and user information
document purpose
Chapter 2 20
document purpose
The purpose of this document is to provide information on installing,
customizing and using hp visualization center sv6 systems. Because the
workstations will arrive racked, pre-cabled and pre-configured, minimal
information about hardware setup is included in this document. Sections
of this document provide steps for setting up and configuring systems.
There are also sections that provide instructions on how to use hp
visualization center sv6-specific tools. Refer to the Glossary for
definitions of terms used in this document.
See the following documents for additional information:
• hp visualization center sv6 Site Prep Guide for cooling, space and
power requirements, etc.
• hp visualization center sv6 Troubleshooting Guide - see
http://www.hp.com/go/workstationsupport for tips on how to resolve
problems you may encounter during the initial setup and
customization.
• hp disk system ds2100 - see
http://www.hp.com/products1/storage/disk_arrays/disksystems/ds
2100/supplies/index.html
• /etc/X11/X0screens for X server configuration details or
/usr/lib/X11/Xserver/misc/slsd/templates/ for hp
visualization center sv6 X0screens templates.
• /usr/lib/X11/Xserver/info/screens/hp for non- hp
visualization center sv6 X server configuration details.
• / opt/graphics/OpenGL/sv/doc/README.* for details about hp
visualization center sv6 tools.
section descriptions
• Product Overview - Provides a general hardware and software
architecture overview.
• Installation - Steps that the hp visualization center sv6 installer
will help you accomplish.