HP sv6 - Manual (Page 63)

installation and user information
usage
Chapter 2 63
instance, if you have a three channel system, but you want to
temporarily set the configuration to use only two of the channels, you
could save the current X0screens file and move a two channel
template into place:
cp /etc/X11/X0screens /etc/X11/X0screens.orig
cd /usr/lib/X11/Xserver/misc/slsd/templates
cp X0screens.p16c2 /etc/X11/X0screens
. . . or
ln -s /etc/X11/X0screens.16c2 /etc/X11/X0screens
NOTE Early versions of SLS/d required the /etc/X11/X0devices and
/etc/X11/X0screens files on the slave systems to be edited. This is
no longer necessary, since the master system uses the information in
its X0screens file to do automatic configuration on the slaves via the
X server.
changing resolution
Use one of the methods below to specify the resolution in the
/etc/X11/X0screens file. Each method automatically sets all graphics
cards in the hp visualization center sv6 configuration to the specified
resolution. If no video timing information is specified, the default
settings will be used.
Do not use the setmon program to change resolutions on your systems. It
does not have the functionality to change all necessary settings.
• Standard Resolutions:
To set a standard resolution, add the following lines to the
ScreenOptions section of the /etc/X11/X0screens file. The
example below is the default for fx
10
graphics cards in an hp
visualization center sv6 configuration (1280x1024 at 75 Hz):
ScreenOptions
SlsdVideoTimingWidth 1280
SlsdVideoTimingHeight 1024
SlsdVideoTimingFrequency 75