HP sv6 User Manual
Page 40
installation and user information
installation process
Chapter 2
40
•
Verify that the switches on all workstations, Compositors, and
any additional equipment are plugged into the PDU, or directly
into an outlet that meets the requirements of the hp
visualization center sv6 Site Prep Guide.
•
Attach keyboard and mouse to the system labeled master.
•
Plug in any ‘dangling’ cables that are needed to connect the racks
together. All cables will be labeled for where they need to be
plugged in.
•
Attach your display device to the output card of the compositor.
Use a standard analog monitor cable. Note that two output cards
will be connected to the output device(s) if you are using passive
stereo as pictured in Figure 2-12. The left output card
corresponds to the left eye and the right card corresponds to the
right eye.
Figure 2-12 Connecting Compositor to Monitor or Other Display Device
•
Connect hp ProCurve 10/100 (J4813A) to site’s Local Area
Network.