Information codes, Troubleshooting – Dacor Contemporary 36 Inch Freestanding Professional Gas Smart Range Use and Care Manual User Manual

Page 98

English

Troubleshooting

Problem

Possible cause

Solution

The oven racks
are difficult to
slide.

The shiny, silver-colored racks
were cleaned in a self-cleaning
cycle.

Apply a small amount of
vegetable oil to a paper towel,
and then wipe the edges of the
oven racks with the paper towel.

The oven door is
locked.

The circuit breaker has been
tripped or there was a power
failure while the oven door was
locked.

Activate Control Lockout, and
then unlock the control. See the

Child Lock

section on page

Information codes

Oven

Displayed

code

Possible cause

Solution

C-d0

This code occurs if the control key is
short for 1 minute.

Clean the buttons and make sure
there is no water on/around
them. Turn off the oven and try
again. If the problem continues,
contact a local Dacor service
center.

C-d1

This code occurs if the door lock is
mispositioned.

Press

OFF

, and then restart the

oven. If the problem persists,
disconnect all power to the oven
for at least 30 seconds and then
reconnect the power. If this does
not solve the problem, call for
service.

C-F0

This code occurs if communication
between the Main and Sub PBA is
interrupted.

C-F2

This code occurs if communication
between the Main and Touch is
interrupted.

C-20

The oven sensor is open when the
oven is operating.
The oven sensor is short when the
oven is operating.

C-21

This code occurs if the internal
temperature rises abnormally high.

Restart the appliance.

NX9900R_PRO RANGE_DOP36M96GL_DG68-01105C-02_EN.indd 98

2019-07-29 10:52:51