Ignition, Ignition 28, Using the cooktop – Dacor Contemporary 36 Inch Freestanding Professional Gas Smart Range Use and Care Manual User Manual
Page 28
English
28
Using the cooktop
Using the cooktop
Ignition
LO
MED
OFF
H
I
NOTE
Each control knob has a corresponding
burner. The location of corresponding
burner is marked next to the knob.
To light a burner :
1.
Push in the knob and turn it counterclockwise to the Lite position. The igniter for
the burner will spark repeatedly until it lights. The spark makes a “clicking” sound.
The burner should light within four seconds. The flame should burn evenly around
the burner, except underneath each grate support finger, where the flame height is
reduced by Dacor’s Smart Flame feature. A normal flame is steady and blue. Foreign
material in the gas line, especially in new construction, may cause a temporary orange
flame during initial operation. Small yellow tips on the flames are normal when using
LP gas. If a burner does not ignite, the igniter continues to spark or if the flame is not
spread evenly around the burner cap, see the
section on page
2.
Place the cooking utensil on the grate.
3.
Adjust the flame to the cooking task.
NOTE
Turn off the burner if there is no spark, and verify that power is supplied to the range.
Never manually light a burner during a power failure.
NX9900R_PRO RANGE_DOP36M96GL_DG68-01105C-02_EN.indd 28
2019-07-29 10:52:36