Canon EOS-1D X Mark III DSLR Camera (Body Only) - Manual (Page 573)

Connecting Manually to Detected Networks
Instructions in this section are continued from Checking the Type of Access Point .
Connect to an access point by selecting its SSID (or ESS-ID) in a list of active access points
nearby.
Selecting the access point
1.
Select an access point.
(1) SSID
(2) Security icon (only for encrypted access points)
(3) Channel used
Turn the < > dial to select the access point to connect to in the list of
access points.
Note
[Refresh]
To display [ Refresh ], scroll down the screen in step 1.
Select [ Refresh ] to search for access points again.
Entering the access point encryption key
Enter the encryption key (password) set on the access point. For details on the
encryption key that has been set, refer to the access point's user manual.
The screens displayed in steps 2–3 vary depending on the authentication and
encryption set on the access point.
Go to
Setting the IP Address if the [ IP address set. ] screen is displayed instead of the
screens shown for steps 2–3.
573