Datavideo SE-4000 8-Channel 4K Video Switcher - Manual (Page 35)

35
Once selected, click OK to start the scanning process.
Note: Please make sure that the selected interface card is in the same network segment as
the SE-4000.
The software should connect with the switcher’s main unit over the IP set up in Section 2.2 .
If the connection is successfully established, on the software user interface, the Connect
Status will show “Connected” (will display Not Connected if disconnected).
Brief descriptions of buttons on the MENU SELECT pane are outlined as follows:
 Home: Interface main page showing connection status and transition time settings.
 User: User memory import
 Still: Still image import

Clip: Clip file import
 Logo: Still logo import
 Ani-Logo: Animated logo import

Setup: Software settings
4.1 Home
As soon as the program is opened, you will see the interface home as shown in the diagram
below. The function items are described as follows:
 Connect Status: Shows “Connected” if the program establishes connection with the
switcher successfully; shows “Not Connected” otherwise.
 ME Trans: Sets MIX EFFECT transition time in frames. See also GUI Menu  Start 
M/E.
 DSK Trans: Sets DSK transition time in frames. See also GUI Menu  Start  DSK.
 FTB Trans: Sets Fade-to-Black transition time in frames. See also GUI Menu  Start 
FTB.