Datavideo SE-4000 8-Channel 4K Video Switcher User Manual
Page 13
13
Ethernet Port
The DVIP port can be used to connect the control panel
to the switcher’s main unit or the network.
If the DVIP port is used to directly connect the main unit,
open the GUI menu and follow the menu path Setup
Network to set the IP address.
The main unit and the control panel can also be
connected to any network at the same time for remote
control. See
for setup
instructions.
Grounding Terminal
When connecting this unit to any other
component, make sure that it is properly
grounded by connecting this terminal to an
appropriate point. When connecting, use the
socket and be sure to use wire with a cross-
sectional area of at least 1.0 mm
2
.
The power button starts and shuts
down the control panel power.
Note: After the power button is
pressed, you will be prompted on
the 5 inch LCD screen to confirm the
shutdown. Select YES and the last
device settings will be automatically
saved before it’s turned off.
DC IN 12V
Connect the supplied
12V PSU to the power
socket.
SERVICE Port
Connect the USB drive
containing the control panel’s
latest firmware files to this port
for device firmware upgrade.